Aero Assemblies, Inc. - Wire Rope End Fittings

Page 1 | Page 2

	THREADED STUDS (1/16" \| 3/32" \| 1/8" \| 3/16") Threaded Studs are used as a method of fastening wire rope assemblies where an overall length adjustment is required. Many diameters and thread pitches are available to fit various applications. Virtually all threaded studs are swaged with a hex pattern for ease of adjustment and meet or exceed the minimum breaking strength of the selected wire rope. Click sizes for specifications:
	THREADED PLUGS Available for 3/32" through 3/16" wire rope diameters.
	MOLDED EYES Molded Eye Fittings offer the same characteristics as stamped eye fittings. They offer a center of gravity pull on the cable. This has advantages over stamped eyes in that the design can influence weight and balance. We currently offer these fittings for 3/32", 1/8" and 3/16" cable diameters with a 7/16" hole in a zinc finish.
	STAMPED EYES Stamped Eye Fittings are used for fastening one or both ends of a wire rope assembly. Stamped eyes are designed to fasten flush to a surface and can be fastened with any round fastener such as a bolt or rivet.
	SLEEVES Sleeves are used to make loops on the end(s) of a wire rope assembly. We stock aluminum for sizes 3/64” through 3/8” diameter cable. Copper is also available for applications susceptible to aluminum corrosion. Thimbles and spools can be used to minimized wear on the inside of a cable loop.
	STOPS Stops are used to do just as the name implies, “stop” the cable from slipping through a hole or cable spool. They are often used with garage door assemblies. Aluminum is the most common material used for stops. Copper and stainless steel are also available but not stocked. Both Aluminum and copper stops are designed to hold one third the minimum breaking strength of the wire rope assembly.