 |
| 1.
Using
the Cable Cutter, cut the Cable to desired length,
making sure to allow for loops. Place one end of the cable through
one side of the Cable End Sleeve then through the D-Ring
& Clip and form a loop inserting the cable end
back through the other side of the sleeve. Allow the cable to
protrude slightly through the end of the sleeve. |
|
 |
| 2.
Using
the Crimper, crimp the sleeve twice, once on each end
of the sleeve. Repeat this process on the other end of the cable
attaching th 1" Round Ring. |
|
 |
| 3.
To
secure merchandise, place the end of the cable with the D-Ring
through the handle on the merchandise and then through the 1"
Round Ring on the other end. |
|
 |
| 4.
Then
place the 6-32 AVSAFE Screw through the Finishing
Washer and through the small hole in the D-Ring & Clip.
Thread the 6-32 Well Nut onto the AVSAFE Screw with the
flange toward the D-Ring. Thread this only a few turns so that
it is held on the screw but not distorted. |
|
| 5.
Place
the Well Nut into any 1/4" hole in the shelf
or store fixture (holes may be round, diamond shaped or square, but
the Well Nut should have a snug fit before setting
if it is to hold properly). |
6.
Using
the AVSAFE Screw Driver, turn the screw until the Well
Nut is securely in place. This may require quite a few turns
since the Well Nut is rather long. |
7.
The
Well Nut can be removed and reused over and over
as long as the rubber does not show signs of
damage. |
|
